Partner RP-300 - Page 77

TITLE : RP-300/310
Page -76 -
2 - - - Undefined.
Off 00 0 No auto cutter error
3
On 08 8 Auto cutter error occurred
4 Off 00 0 Not used. Fixed to Off
Off 00 0 No unrecoverable error
5
On 20 32 Unrecoverable error occurred
Off 00 0 No automatically recoverable error
6
On 40 64 Automatically recoverable error occurred
7 Off 00 0 Not used. Fixed to Off
Bit 3: If these errors occur due to paper jams or the like, it is possible to recover by
correcting the cause of the error and executing DLE ENQ
n (1 ≤ n ≤ 2). If an
error due to a circuit failure (e.g. wire break) occurs, it is impossible to recover.
Bit 6: When printing is stopped due to high print head temperature until the print head
temperature drops sufficiently or when the paper roll cover is open during printing,
bit 6 is On.
Third byte (paper sensor information)
Bit Off / On Hex Decimal Status for ASB
Off 00 0 Paper roll near-end sensor: paper adequate
0,1
On 03 3 Paper roll near-end sensor: paper near end
Off 00 0 Paper roll end sensor: paper present
2,3
On 0C 12 Paper roll end sensor: paper not present
4 Off 00 0 Not used. Fixed to Off
5,6 - - - Undefined
7 Off 00 0 Not used. Fixed to Off
Fourth byte (paper sensor information)
Bit Off / On Hex Decimal Status for ASB
0-3 - - - Undefined
4 Off 00 0 Not used. Fixed to Off
5,6 - - - Undefined
7 Off 00 0 Not used. Fixed to Off.
[Default] n = 0.
[Reference] DLE EOT, GS r
GS f n
[Name] Select font for Human Readable Interpretation (HRI)characters
[Format] ASCII GS f
n
Hex 1D 66
n
Decimal 29 102
n