Need help?Do you have a question about the Paslode IM350 and is the answer not in the manual?
Read safety manuals, understand instructions, check safety yoke for smooth operation.
Use for timber-to-timber fixings; avoid combustible environments.
Load battery with contacts facing down, press until clip engages. Remove by pressing clip.
LED indicates battery in tool, empty, or ready. Clean contacts if necessary.
Remove cap, insert fuel cell, align stem with orifice, close cover carefully.
Pull follower back, insert fasteners, release follower gently. Avoid damaging collation.
Reload when follower reaches 'reload' arrow. Unload by pulling follower back.
Lockout activates with 4-5 nails remaining. Do not depress trigger when loading.
Both work contact element and trigger must be actuated sequentially for operation.
Intermittent: 2-3 nails/sec. Continuous: 1000 nails/hour. Avoid overheating.
Depress contact element, squeeze trigger, release tool. Fan cools tool after nailing.
Fan runs for approximately 10 seconds after nailing is completed for tool cooling.
Slacken screws on work contact element, move bracket to adjust penetration depth.
Remove fuel/battery, remove fasteners, undo magazine screws, ease magazine, remove jam.
Read safety manuals, understand instructions, check safety yoke for smooth operation.
Use for timber-to-timber fixings; avoid combustible environments.
Load battery with contacts facing down, press until clip engages. Remove by pressing clip.
LED indicates battery in tool, empty, or ready. Clean contacts if necessary.
Remove cap, insert fuel cell, align stem with orifice, close cover carefully.
Pull follower back, insert fasteners, release follower gently. Avoid damaging collation.
Reload when follower reaches 'reload' arrow. Unload by pulling follower back.
Lockout activates with 4-5 nails remaining. Do not depress trigger when loading.
Both work contact element and trigger must be actuated sequentially for operation.
Intermittent: 2-3 nails/sec. Continuous: 1000 nails/hour. Avoid overheating.
Depress contact element, squeeze trigger, release tool. Fan cools tool after nailing.
Fan runs for approximately 10 seconds after nailing is completed for tool cooling.
Slacken screws on work contact element, move bracket to adjust penetration depth.
Remove fuel/battery, remove fasteners, undo magazine screws, ease magazine, remove jam.
General| Weight | 3.3 kg |
|---|---|
| Nail Length | 51 - 90 mm |
| Firing Mode | Sequential or Bump Fire |
| Type | Framing Nailer |
| Power Source | Gas and Battery |
| Magazine Capacity | 55 Nails |
| Nail Diameter | 2.8 - 3.1 mm |
| Operating Temperature | -15°C to 49°C |
| Nail Gauge | 11-12 gauge |
To Next Page