Need help?Do you have a question about the Passion Veneto and is the answer not in the manual?
General| Manufacturer | Passion Spas |
|---|---|
| Number of Seats | 6 |
| Heater | 3 kW |
| Seating Capacity | 6 persons |
| Shell Material | Acrylic |
Pre-water addition checks to prevent common issues during initial spa setup.
Step-by-step guide on how to properly fill the spa with water.
Procedures for testing the electrical system and initiating spa operation.
Control basic spa devices and access Standby and Economy features via the topside panel.
Access and program various spa settings including filter, economy, display, and security.
Customize filter purge cycle start time and frequency for optimal operation.
Configure economy mode to reduce operating costs by adjusting water temperature.
Adjust contrast, backlight, video, and orientation of the spa display.
Control audible beep functions for keypad presses and warning alarms.
Set language, temperature units (F/C), and time format (12/24 hour).
Reset keypad settings to their original factory default values.
Procedure for service personnel to perform firmware upgrades on the keypad.
Identifies causes and solutions for circuit breaker tripping issues.
Addresses causes like GFCI issues or temperature limits affecting pump operation.
Explains causes like soaps or undissolved sanitizer and suggests solutions.
Troubleshoots leaks caused by loose connections or open drain valves.
Diagnoses issues with spa lighting due to burnt bulbs or wiring.
Covers causes like dirty filters or closed jets impacting water pressure.
Addresses issues arising from spa relocation, such as wiring errors or power loss.
Troubleshoots complete system failure due to tripped breakers or wiring.
Addresses pumps running continuously due to filtration system settings.
Diagnoses issues with the speaker pop-up mechanism.
Covers air locks, closed jets, or open air control valves preventing water flow.
Addresses high water temperatures due to set point or ambient conditions.
Troubleshoots heating issues caused by thermostat settings, filters, fuses, or valves.
Device not detected error and corrective action.
GFCI breaker error and corrective action.
Air-locked pump error and corrective action.
Pump error codes and corrective actions.
Water high limit temperature exceeded error and corrective action.
Topside control panel not connected error and corrective action.
Water not flowing error and corrective action.
No heat error and corrective action.
Improper BR setting error and corrective action.
Blown fuse errors (F1, F2, F3) and corrective actions.
Internal hardware error and corrective action.
Input voltage low error and corrective action.
Water temperature overheat error and corrective action.
Procedure to reset the spa pack to its default settings.
Adjusting the breaker current setting (Br) for different spa configurations.
Resetting and setting the low-level setting (LL) for various spa models.
To Next Page