PAT DS 350 - Quick Hoist Line Selection

Operator's Manual DS 350 / 1361 RT 875 CC
© PAT Revision E // SB // 09/03/02 190137_E
16
4.3 Quick Hoist Line Selection
If, during the crane operation, the crane is switched over from front to rear hoist, the LMI
system has to be adjusted to this modification. This modification can be entered without
having to go through the whole LMI setup procedure again:
Call LMI setup procedure.
Directly call function "Hoist
Line Selection".
Note:
The direct call is not possible,
if the system has been turned
off for more than 2 hours.
Select hoist:
Front Hoist
Rear Hoist
Confirm modification.
(call up the function again if
you have selected the wrong
winch by mistake)
Note:
If a configuration is selected which is not available on the crane, the system will not
accept the selection and the display will indicate the error code E04.