PAT DS150 - Addendum a Basic Adjustment and Voltage Checks

Error Codes
47
ADDENDUM A BASIC ADJUSTMENT AND VOLTAGE CHECKS
MODEL:
S/N:
PAT DS150 P/N 024-150-060-002 central unit / 024-150-300-001 main board
1. Crane Supply Voltage @ X1-1 (+) & X1-4 (GND) = VDC
2. Main Board Power Supply (Reference Voltages +/ -50 MV):
+ 9V @ Mp2 = VDC Mp 10 Ground - Piston & Rod Pressure
- 9V @ Mp3 = VDC Mp 10 Ground - Piston & Rod Pressure
5V @ Mp4 = VDC Mp 10 Ground – TTL on Board
5V @ Mp5 = VDC Mp 10 Ground – Reference on Board
+ 5V @ Mp6 = VDC Mp 10 Ground – Internal on Board
- 5V @ Mp7 = VDC Mp 10 Ground – Length and Main/Jib Angle
4. Boom Length: (MP10 Ground for Meter)
Fully Retracted Ft.
Fully Extended Ft.
VDC @ X1:10 DC @ MP13
VDC @ X1:10 DC @ MP13
-5 Volt Reference Voltage VDC @ X1:11
5. Boom Angle: (MP10 Ground for Meter)
Minimum Angle 
Maximum Angle 
VDC @ X1:9 VDC @ Mp14
VDC @ X1:9 VDC @ Mp14
-5 Volt Reference Voltage VDC @ X1:11
6. Pressure Transducers: (MP10 Ground for Meter)
Piston Zero Point VDC @ X1:21 VDC @ Mp11
Rod Zero Point VDC @ X1:16 VDC @ Mp12
+5 Volt Reference Voltage VDC @ X1:13 & 18
-5 Volt Reference Voltage VDC @ X1:15 & 20