DS350GM - BOOM CONTROL EXTENSION RT 865BXL 9
031-300-190-047 Rev0 02/17/1999
Correct?
Faulty switch wiring or
defective switch. Replace IM
reset proximity switch. Adjust
switch and target. Refer to
section 2, drawing 2.1.
Yes
No
Measure the IM reset switch signal at wire 2
(+24V)(fast-on connector) and terminal 3 (GND) in the
length transducer LG321. Refer to section 2, drawing
2.3 and 2.12.
Measure the IM retract switch signal at terminal 4
(+24V) and 5 (GND) in the switch junction box.
Refer to section 2, drawing 2.2 and 2.12.
Continue on next
page
Correct?
Yes
Faulty wiring between length
transducer LG 321 and switch
junction box. Check wiring.
No
Continuation
To Next Page
Loading...
