Patlite LR4 - Specifications

51
Buzzer sound No.4 was measured from the total circumfrence of the Buzzer Unit at 1m
Max.
Buzzer Unit：40mA (※1)
LED Unit：40mA
24V DC
Operating Voltage Range
Rated Voltage ±10%
Typ.
Signal Wire Current
Rated Voltage
（Per Unit）
Rated Power
Consumption
（Per Unit）
Buzzer Unit ： 1W (※1)
LED Unit ： 1W
LED Unit ： 1.3W
Buzzer Unit ： 1.3W (※1)
60±2 Flashes Per Minute
Upright
Upright
IP65(IEC 60529) / NEMA TYPE 4X,13
IP54(IEC 60529) / NEMA TYPE 4X,13
IP65(IEC 60529) / NEMA TYPE 4X,13
When using POLE22-□□□□AT : IP54(IEC 60529) / NEMA TYPE 4X,13
Mass
(Tolerance ±10%)
Inrush Current
none (Signal Wire Current Maximum not exceeding the sum total)
Mounting Direction
Environmental Condition
Setting
0.20kg + (0.040kg)×Tiers + [0.050kg]
0.49kg + (0.040kg)×Tiers + [0.050kg]
0.38kg + (0.040kg)×Tiers + [0.050kg]
0.15kg
0.22kg + (0.060kg)×Tiers + [0.060kg]
0.50kg + (0.060kg)×Tiers + [0.060kg]
0.40kg + (0.060kg)×Tiers + [0.060kg]
0.46kg + (0.060kg)×Tiers + [0.060kg]
0.17kg + (0.035kg)×Tiers + [0.035kg]
0.46kg + (0.035kg)×Tiers + [0.035kg]
0.36kg + (0.035kg)×Tiers + [0.035kg]
0.42kg + (0.035kg)×Tiers + [0.035kg]
(LED Unit) + [Buzzer Unit]
Insulation Resistance
Sound Pressure Level
Typical 90dB
Typical 88dB
Typical 85dB
Typical 85dB
Outer Dimensions
Refer to Section 3 “
Part Names and Outer Appearance”
More than 1MΩ at 500VDC between live part and non-current carrying metallic part
Remarks
UL 508, CSA-C22.2 No. 14, EMC Directive (EN 61000-6-4, EN 61000-6-2)
RoHS Directive (EN 50581), FCC Part 15 Subpart B Class AConformity Standards
KC (KN 61000-6-4, KN 61000-6-2) (※2)
Buzzer Sound/
Typical Frequency
Buzzer Unit：250mA (※1)
LED Unit：45mA
Operating Ambient Temperature
Operating Ambient Humidity
Storage Ambient Temperature
Storage Ambient Humidity
Mounting Location
Withstand Voltage
Flashing Rate
Environmental Condition
-20℃ 〜 +50℃
Less than 90% RH (No Condensation)
-30℃ 〜 +60℃
Less than 90% RH (No Condensation)
Indoor Only
Model
LR□-□02□□□□
Power Supply Wire
Signal Wire
Buzzer Unit：none (Not exceeding Maximum Signal Wire Current Ratings)
LED Unit：none
Standby Power Consumption
LED Unit ： none
Buzzer Unit ： 0.1W
Body Unit ： none
500VAC applied for 1min between live part and non-current carrying metallic part without breaking insulation
No.1
LR7
LR4
QJ
PJ
LJ
WJ
QJ
PJ
LJ
WJ
WJ
WT
PJ
LJ
WJ
LR5
LR6
LR7
LR4
LR5
LR6
No.2
No.3
No.4
Rapid Intermittent Beep / 3378Hz
Continuous Beep Sound / 3378Hz
Rapid Hi-Lo / 2016Hz&3012Hz
Depending on DIP Switch settings.Refer to Section 6 “Buzzer Pattern Set-up”.
Sweep Sound / 1000Hz-4032Hz
(※1) Environmental Condition: Buzzer Sound No.2 (Continuous Beep Sound)
(※2) Except KT, Assembly Model WT
UL Recognized Component (File No.E215660)
Max.
Typ.
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white
Off-white/Silver/Black
0.32kg + (0.035kg)×Tiers + [0.035kg]
0.61kg + (0.035kg)×Tiers + [0.035kg]
0.51kg + (0.035kg)×Tiers + [0.035kg]
0.35kg + (0.060kg)×Tiers + [0.060kg]
0.53kg + (0.060kg)×Tiers + [0.060kg]
0.64kg + (0.060kg)×Tiers + [0.060kg]
Silver
Silver
Silver
Silver
Silver
Silver
0.24kg + (0.065kg)×Tiers + [0.070kg]
Protection Rating
Sound Reduction approximately -10dB,
depending on DIP Switch settings.
Refer to Section 6 “Buzzer Pattern Set-up”
● This product is designed for use on a flat surface for a Type 1 Enclosure. (Conformity requirements for UL Standard)
● Use a "class 2" power supply specified in the guidelines under UL1310. (Conformity requirements for UL Standard)
● This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These restrictions are limited to cases where this equipment is operated in a business district, and it is designed to take the
relevant protective measures against electromagnetic noise hindrance.
● This product must not be used in residential areas. (Conformity requirements for the CE Marking)
Due to the characteristics of the LED elements, a variation in difference of the color tone and brightness
of every product may occur.
0.10kg
0.10kg
KT
Off-white/Silver/Black
Silver/Black
0.15kg
KT
Off-white/Silver/Black
LJ
KT
0.10kg+ (0.040kg)×Tiers + [0.050kg]
WT
Off-white
General Specifications（ 02 WJ LJ PJ QJ WT KT ）
Specifications
10
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de