How to use the Test Light
Transmitter.
Save the Test Light for future testing.
Note: If the Test Light does not flash, recharge
Note: At higher Shock Levels, the Test Light
1. Turn the Receiver Collar on.
Points.
4. The Test Light will flash.
will flash brighter.
2. Hold the Test Light Contacts to the Contact
3. Press the SHOCK Button on the Remote
5. Turn the Receiver Collar off.
the Receiver and re-test. If Test Light still does
not flash, contact us for Customer Service.
Step
10
18 19
Step
9
How to pair the Remote
Transmitter & Receiver Collar
If your Receiver Collar does not beep when the TONE
Button of the Remote Transmitter is pushed,or if you
feel the Receiver Collar is not responding to the Remote
Transmitter, follow these steps to pair:
Two Dog System
NOTE: If you wish to add another Receiver Collar to
Dog 1/2 Button.
2. Turn on the Receiver Collar for Dog 2, press any
the training system, extra Receiver Collars are available
where you bought your unit.
Remote Transmitter
1. Switch Dog1 to Dog2 by pressing and releasing the
may be needed.Repeat steps in How to pair the Remote
Transmitter & Receiver Collar above.
Mode Buttons to verify function.
3. If Dog 2 Receiver Collar does not respond. Pairing
2. Press any of on the transmitter,
the Green LED Light on the Receiver Collar flashes
rapidly for 5 times which means pairing is completed.
1. With the Receiver Collar off your pet, turn the
Receiver Collar off. Restart, press and hold the On/Off
Button until the Green LED flashes every second on
the Receiver Collar.
To Next Page
Loading...
