PAVONE DAT 500 - Serial Output Parameters

Page 32
Inout
SET
FUN
SEr1aL
SET
FUN
Config
baUdr
prot-1
prot-2
IP-Add
subnEt
dELay
rEN-Co
t-NAP
r-Nap
dELNap
0
0
0
0
0
0
0
0
0
0
PRG
SET FUN
SET FUN
SET FUN
SET FUN
SET FUN
SET FUN
SET FUN
SET FUN
SET FUN
SET FUN
PRG
Select Value
PRG
PRG
Select Value
PRG
PRG
Select Value
PRG
PRG
PRG
PRG
Enter Value
PRG
Remote
connection
PRG
PRG
PRG
0
data F
0
SET FUN
PRG
Enter Value
PRG
PRG
trasN-
End-oh
0
rECEIV
End-oh
ErasE
End-oh
PRG
0
IP-Ad1
PRG
000
123
PRG
Enter Value
SET FUN
IP-Ad4
0
PRG
…
PRGPRG
…
0
SnEt 1
PRG
000
123
PRG
Enter Value
SET FUN
SnEt 4
0
PRG
…
PRGPRG
…
AddrEs
0
SET FUN
PRG
Enter Value
PRG
SERIAL OUTPUT PARAMETERS
This menu allows you to set the serial ports COM1 and COM2 and the communication parameters.
The instrument has two independent serial ports:
COM1 with RS232 or RS422/RS485 interface
COM2 with optional FIELDBUS interface.
baUd r BAUD RATE COM1
It defines the baudrate of the RS232 serial port.
The value must be set to the same value of the PC / PLC or remote
display.
Value to be selected:
2400
9600
19200
38400
115200
Default: 9600
baud2r BAUD RATE COM2 (DEVICENET VERSION)
It defines the baudrate of the DEVICENET interface.
The value must be set to the same value of the PC/PLC.
Value to be selected:
125 250 500 DeviceNet
Default:
125 DeviceNet
Prot-1 COM1 PROTOCOL
It defines how to use the RS232 serial port
None: Serial communication OFF
Contin: Continuous transmission of the weight string. It can be used,
for example, to drive a weight repeater. See details in the relevant
paragraph.
Demand: When the Operator presses the front button or through
Input 2, a string of weight is transmitted. The command is accepted
if the weight is stable. Between two consecutive transmissions the
weight must have a variation of at least 20 divisions.
Autom-: It’s automatically transferred to a string of weight when the
weight stabilizes at a value higher than the minimum weight (20
divisions). Between two consecutive transmissions, the weight must
have a variation of at least 20 divisions.
Slave: ASCII protocol. See details in the relevant paragraph.