PAX S300 Quick Reference Guide

MENU LAYOUT AND KEY USAGE
• The PAX S300 has two menu menus: Transaction and
Administration (ADMIN)
• Use the on-screen scroll arrows to navigate the menus
• To enter letters using the numeric keypad, press the number
key for the corresponding letter and then press the ALPHA key
until the desired letter appears
• Press 0 (zero) and then the ALPHA key to enter a space
• Press the on-screen Up arrow and then the ALPHA key to enter
special characters
• To confirm an entry, press the green key
• To correct an entry, press the yellow key
• To cancel a function, press the red X key
PREPARING THE TERMINAL FOR USE
1. Turn the terminal over and remove the back cover (you may
need to remove one screw).
2. Install the S300 connector cable to the terminal.
3. Replace the terminal’s back cover (fasten the screw if required).
4. Connect power adapter cable to S300 connector cable.
5. If using an Ethernet connection:
a. Connect an Ethernet cable to red LAN connector of the S300
connector cable.
b. Connect the other end of the Ethernet cable to your
network router.
6. If using a serial connection:
a. Connect the S80 download cable RJ11 plug to the blue
RS232A connector of the S300 connector cable.
b. Fasten the two DB-9 connectors together.
c. Connect the DB-9 to USB serial connector to a USB plug on
the POS system.
7. Press the terminal’s red cancel X button to exit ECR mode.
8. Enter administrator password to enter Admin mode.
9. To return to ECR mode press yellow key.
CHANGING TEMPORARY ADMIN PASSWORD
1. Press the on-screen Up arrow to access the ADMIN menu.
2. Press 9 to access the PASSWORD menu.
3. Press 2 for ADMIN PWD.
4. Enter the temporary admin password (000000) and press the
green key.
5. Enter the new admin password and press the green key.
6. Re-enter the new password to confirm and press the green
key.
COMMUNICATION TO HOST SET-UP
NOTE:
If you have not already, change the temporary Admin
password.
1. Press the on-screen Up arrow to access the ADMIN menu.
2. Press 3 for SETUP.
3. Press 2 for HOST SETUP.
4. Enter the admin password and press the green key.
5. Enter the assigned MERCHANT ID (provided by PayFacto) and
press the green key to confirm.
6. Enter the assigned TID (Terminal ID, provided by PayFacto) and
press the green key to confirm.
7. Select the FALLBACK TO DIAL option: press 1 for Yes or 2 for No.
NOTE
: If you select Yes, ensure that the terminal has
a telephone connection.
8. Select the INPUT TYPE: press 1 for IP or 2 for NAME.
9. Enter the information provided by PayFacto for the following
parameters and press the green key to confirm:
• IP ADDRESS or IP NAME (according to the option selected in
step 8)
• PORT
• CTP GWAY URL
• CTP GWAY PORT
10. Press the red X key two times to return to the main screen.
HOST DOWNLOAD
1. Press the on-screen Up arrow to access the ADMIN menu.
2. Press 6 for MAINTENANCE.
3. Press 1 for PARAM DLL.
4. Press the green key to perform the download.
5. After the download completes, press 2 for EMV KEY DLL.
6. After the download completes, press 3 for ASSOCIATION.
NOTE: This step is only required if the terminal will be used as a
wireless device.
S300 Integrated Mode
Quick Reference Guide

PAX S300 Specifications

General

Processor	32-bit ARM11
Security	PCI PTS 3.x approved
Card Readers	Magnetic Stripe, Contactless
Connectivity	RS232, USB, Ethernet
Memory	128MB Flash, 64MB SDRAM