EasyManua.ls Logo

Payne PG92S S Series - User Manual

Payne PG92S S Series
85 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
PG92SCS ALL
PG92SBS 048080 ONLY
Installation, Start-up, Operating and
Service and Maintenance Instructions
Single-Stage 4-Way Multipoise
Condensing Gas Furnace
NOTE: Read the entire instruction manual before starting the installation.
SECTIONS
SAFETY CONSIDERATIONS 3.........................
INTRODUCTION 4...................................
CODES AND STANDARDS 4...........................
ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS 5...
ACCESSORIES 5.....................................
LOCATION 8........................................
AIR FOR COMBUSTION AND VENTILATION 9..........
CONDENSATE TRAP 13...............................
CONDENSATE DRAIN 17.............................
INSTALLATION 21...................................
AIR DUCTS 31.......................................
GAS PIPING 33......................................
ELECTRICAL CONNECTIONS 34.......................
VENTING 40........................................
STARTUP, ADJUSTMENT, AND SAFETY CHECK 64......
SERVICE AND MAINTENANCE PROCEDURES 73........
SEQUENCE OF OPERATION 81........................
PARTS REPLACEMENT GUIDE 85......................
CERTIFIED
Use of the AHRI Certified
TM
Mark indicates a
manufacturers participation in the program. For
verification of certification for individual products,
go to www.ahridirectory.org.
Portions of the text and tables are reprinted from current edition of
NFPA 54/ANSI Z223.1, with permission of National Fire
Protection Association, Quincy, MA 02269 and American Gas
Association, Washington DC 20001. This reprinted material is not
the complete and official position of the NFPA or ANSI on the
referenced subject, which is represented only by the standard in its
entirety.
TABLES
Loose Parts Bag 5.....................................
Minimum Clearances to Combustible Materials 5.............
Minimum Free Area Required 11.........................
Minimum Space Volumes 11.............................
Filter Size Information 24...............................
Opening Dimensions 26................................
Air Delivery CFM 32...................................
Maximum Capacity of Pipe 34...........................
Electrical Data 34......................................
Vent Termination Kit for Direct Vent (2Pipe) System 42.......
Hangar Spacing 46.....................................
CombustionAir Vent Pipe, Fitting & Cement Material.. 48.....
Maximum Allowable Exposed Vent Lengths Insulation 49......
Maximum Equivalent Vent Length 50......................
Deductions from Maximum Equivalent Vent Length 50........
Blower Off Delay Setup Switch 67........................
Altitude Derate Multiplier for U.S.A. 68....................
Gas Rate 70..........................................
Orifice Size and Manifold Pressure 71.....................
Question and Answer IconNeed help?

Do you have a question about the Payne PG92S S Series and is the answer not in the manual?

Summary

SAFETY CONSIDERATIONS

ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS PROCEDURE

LOCATION

AIR FOR COMBUSTION AND VENTILATION

INSTALLATION

RETURN AIR CONNECTIONS

AIR DUCTS

GAS PIPING

Gas Piping Safety and Installation

Covers fire/explosion hazards, pipe requirements, and Massachusetts-specific rules.

ELECTRICAL CONNECTIONS

Electrical Safety and Wiring Practices

Details electrical hazards, grounding, J-box installation, and wiring requirements.

VENTING

Venting System Requirements and Materials

Covers general venting, Canadian requirements, materials, and termination support.

START-UP, ADJUSTMENT, AND SAFETY CHECK

Start-Up Procedures and Safety Checks

Outlines essential procedures for initial furnace operation and safety verification.

ADJUSTMENTS

SERVICE AND MAINTENANCE PROCEDURES

Troubleshooting and Component Testing

Procedures for diagnosing issues using status codes and performing component self-tests.

CLEANING BURNERS AND FLAME SENSOR

CLEANING HEAT EXCHANGERS

SEQUENCE OF OPERATION

TROUBLESHOOTING GUIDE

Payne PG92S S Series Specifications

General IconGeneral
BrandPayne
ModelPG92S S Series
CategoryFurnace
LanguageEnglish

Related product manuals