8
(6). key :
c Press this key to switch to display date and time.
d Press and hold this key while turning the meter on to the alarm
setting mode, press key two times to exit this mode.
3 Press this key for 3 seconds to switch the alarm function on or off.
(7).
key : Press this key to enter the current data and time setting
mode, press this key again to exit this mode.
(8).
key :
c Press this key to change sensor axis selector : “All axis” → “X axis”
→ “Y axis” → “Z axis”.
d Press and hold this key while turning the meter on to switch the
device to the calibration factor setting mode, press “SET” key to exit
this mode.
(9).
key :
c Press this key one time to store one data set to memory.
d Press and hold this key while turning the meter on to enter the clear
manually recorded data mode, press
key to exit this mode.
(10).
key :
c Press this key to switch to the manual data reading mode, press this
key again to exit this mode.
d Press and hold this key while turning the meter on to disable the auto
power off function, the “
” symbol will disappear.
(11). STWX key : Setting current date and time, datalogging interval time,
alarm setting value, calibration factor setting value, or recall manual
data memory to read memory data in cycles control keys.
To Next Page
Loading...
