PCE Instruments PCE-EM 29 - Reading Stored Values

20
4-7-2 Reading individual measured values
Z
Y
X
Exit
Entry
Reading mode indicate
Reading memory location
X
Y
Z
1. Press key, the display then shows “ ”(reading mode).
2. Press S or T key to select the desired memory location.
3. Press
key to select the desired reading units.
4. Press
key to select the desired sensor axis reading.
5. Press
key again to exit.
4-7-3 Deleting manual data memory measured values
Once the memory is full, you can clear the entire contents of the
manual data memory.
Hold-on
Power off
+