Manual
20
All the settings from the base unit is mirrored into the PC software, so once you have done your setting
on the base unit, then you don’t need to make any setting changes on the PC software. However you can
still easily make any setting changes you wanted from the PC and download the changes into the base
station (the setting change will be refreshed when next full minute arrives on the base station).
When base unit is connected to PC, the icon of will be displayed. If the base station is not
connected, then will be displayed.
7.4 Function button
: Display and setup system configuration
This section is used to set up PC software display, base station units, as well as able or disable the
corresponding alarm function. Once you made your choice, press Save to make the setting effective.
To Next Page
Loading...
Need help?
General
