Manual
9
5.3 Operation Note
All actions and functions of the weather station are started on the touch screen by slightly touching (not
pressing!) the related areas, touch the flashing +, ON/OFF or – to make the corresponding selection or
increase the value.
Every time a programming step is activated by touching a switching area on the Touch Screen a tone will
sound, and the back light is switched on for a few seconds as well.
If no areas are pressed for 30 seconds, the LCD will automatically revert to the normal display mode
(automatic time out).
On the edge of wind direction sensor, there are four alphabet letter of “N”,”E”,”S” and “W” representing for
the direction of North, East, South and West. Wind direction sensor has to be adjusted so that the
directions on the sensor are matching with your real location. Permanent wind direction error will be
introduced when the wind direction sensor is not positioned correctly during installation.
Wind speed sensor wire has to be inserted into the phone jacket on wind direction sensor. Wind direction
sensor wire has to be inserted into the phone jacket located on the thermo-hygro sensor with marking of
“Wind” on top.
The rain sensor wire has to be inserted into the phone jacket located on the thermo-hygro sensor with
marking of “Rain” on top.
To Next Page
Loading...
Need help?
General
