To Next PageTo Next Page
Need help?Do you have a question about the PCE Instruments PCE-322A and is the answer not in the manual?
General| Brand | PCE Instruments |
|---|---|
| Model | PCE-322A |
| Category | Data Loggers |
| Language | English |
Specifies altitude, humidity, and operating temperature limits for safe operation.
Guidelines for servicing and cleaning the instrument using soft cloth.
Identifies the CE symbol indicating compliance with EMC standards.
How to select between A and C frequency weighting modes.
Controls the LCD backlight, turning on/off and auto-off after inactivity.
Freezes the current reading on the LCD by pressing the HOLD button.
Circularly selects measurement ranges like Lo, Med, Hi, and Auto.
Instructions for turning the meter on and off using the power key.
Enters MAX/MIN mode to display captured maximum and minimum sound levels.
Selects between FAST (125ms) and SLOW (1s) time weighting for measurements.
Procedure to set the meter's date and time using the SET key and navigation.
Toggles the display between current time (HH:MM:SS) and current date (YYYY-MM-DD).
Starts/stops data recording by holding the REC key, with 'Full' indicator for memory limit.
Describes the earphone outlet for AC/DC signal output and grounding.
Details the requirements for external DC 9V power supply input, including polarity and connector size.
Steps to set switch settings, insert microphone into calibrator, and adjust potentiometer.
Informs that the meter is pre-calibrated and recommends annual recalibration.
Instructions for battery installation and recognizing the low battery icon.
How to connect the AC adapter to the DC 9V connector on the side panel.
Steps to power on the meter and select the desired level range.
Selecting dBA/dBC weighting and FAST/SLOW response times for measurement.
Using the button to measure and display maximum and minimum noise levels.
Guidance on holding the meter or using a tripod and optimal distance from the sound source.
How to view current time or date using the SET key.
Introduces the software's menu, toolbar icons for file operations, and saving/opening data.
Details the function for adjusting the meter's time and date based on PC settings.
Describes starting/stopping real-time recording and viewing data curves with zoom capabilities.
Instructions for connecting/disconnecting the meter with the PC and uploading recorded data.
Explains various parameters shown in the real-time display like Start/End Time, MAX/MIN data, Unit, etc.
How to create an A-B graph and access datalogger setup options.
Functions to upload recorded data and clear the meter's memory.
Steps to launch software, connect meter, and configure initial settings like time/date and sample rate.
Starting real-time monitoring, selecting working status, and analyzing data between points on the graph.
Performing zoom out, zoom in, and zoom A operations on the graph.
Details on using toolbar icons for zooming out and displaying the full graph.
Shutting down the meter via the PC software after measurement is complete.
