To Next PageTo Next PageWhy does the PCE Instruments PCE-GA 12 Security Sensors display flash with a continuous signal tone?
The flashing display with a continuous signal tone on your PCE Instruments Security Sensors indicates that the sensor is defective. The suggested solution is to replace the sensor ESS-PCE-GA 12.
How to fix a PCE Instruments PCE-GA 12 that cannot be turned on?
If your PCE Instruments Security Sensors won't turn on, the battery may be flat. To resolve this, charge the battery.
General| Gases Detected | O2, CO, H2S, LEL |
|---|---|
| O2 Resolution | 0.1% Vol |
| CO Measuring Range | 0 ... 1000 ppm |
| CO Resolution | 1 ppm |
| H2S Measuring Range | 0 ... 100 ppm |
| H2S Resolution | 0.1 ppm |
| LEL Measuring Range | 0 ... 100 % LEL |
| LEL Resolution | 1% LEL |
| Alarm | Visual, Audible, Vibration |
| Power Supply | 3.7 V / 1800 mAh lithium-ion battery |
| Dimensions | 135 x 67 x 35 mm / 5.3 x 2.6 x 1.4" |
| Weight | Approx. 200 g |
| O2 Measuring Range | 0 ... 30 % vol |
| Operating Temperature | -20 ... 50 °C |
| Operating Humidity | 15 ... 95 % RH, non-condensing |
| Humidity | 10 ... 95 % RH (non-condensing) |
Instructions for initial charging and acclimatisation of the sensor before the first use.
Procedures for checking mechanical condition and performing a gas test before operating the device.
Guidance on operating the device, including warm-up, sensitivity selection, and leak detection.
Instructions on activating or deactivating the display backlight.
Explanation of the Auto Zero function for improved sensitivity and reduced interference.
Details on the automatic power-off function and how to deactivate it.
How to adjust the device's sensitivity to suit different measurement needs.
Information on how to switch audible and vibration alarms on or off.
