14
Capacitive button is used to:
switch the display illumination on
change the presentation mode of the measurement results -
holding the button for about 2 seconds switches from automatic
mode to manual mode or inversely
change the type of displayed values in the manual mode of presen-
tation of the measurement results - pressing the button for a short
time changes the displayed value.
program communication parameters (address, baud rate, mode)
•
•
•
•
5.4. Programming parameters menu of the P18D transducer
Enter the programming menu by pressing and holding
the capacitive button for approx. 5 sec. When entering the menu a first
time, changes direction marker is set to - increasing the value;
next entry in the menu will cause the cyclic switching of the direction
of changes (2 input in the menu will set the marker at v – decreasing
the value). If the idle time exceeds 20 seconds, the transducer will leave
the menu and switch to displaying the measuring value.
Fig. 9. The displayed information of the transmission parameters in the
P18D transmitter menu
Direction
of changes
Mode
Address
Baud
rate
To Next Page
Loading...