36
6.7 Emergency restoration of default parameters
If the communication parameters have been changed and the
new configuration is lost, you can use the jumper marked „ZW” on the
transmitter’s board to set the temporary communication parameters:
address 247
baud rate 9600 kb/s
mode RTU 8N2
You can connect to the transmitter after setting the temporary parame-
ters and adjust them or restore the defaults settings. After removing
the jumper, the transducer returns to previous settings or to settings
changed during the operation with the jumper.
•
•
•
Fig. 13. Placement of the jumper setting temporary communication
parameters
jumper ZW
To Next Page
Loading...