9
L510010-07A
SAFETY INFORMATION
“Safety Warnings” and additional information or
instructions are used to alert the installer/operator of
possible safety hazards in performing certain service
or maintenance procedures incorrectly or carelessly.
DANGERS and WARNINGS are accompanied by the
international HAZARD symbol:
These “Safety Warnings” alone cannot eliminate the
hazards that they signal. Strict compliance with
these warning instructions while performing service
and maintenance procedures, plus “common sense”
operation, are major accident prevention measures.
REPLACEMENT PARTS
Use of replacement parts (i.e. automotive, after-market,
etc.) in the electrical, ignition and fuel systems, which are
not U.S. Coast Guard approved, could cause a fi re or
explosion hazard and should be avoided.
Always request that genuine PCM Engines replacement
parts be used in any repairs or maintenance being
performed on your engine(s).
DANGER
Electrical, ignition and fuel system components are
designed and manufactured to comply with U.S.
Coast Guard rules and regulations to minimize the
possibility of fi re or explosion hazard.
DANGER
Signals serious damage, failure or breakdown of equipment; severe injury or high probability of death to the user if
proper precautions are not taken. This signal word is applied in extreme situations
SAFETY WARNINGS
WARNING
Indicates a potential hazard which could result in personal injury.
CAUTION
Indicates a hazard which could result in damage to equipment.
WARRANTY NOTICE: Indicates a possible warranty exclusion.
INTRODUCTION - 1
IMPORTANT: or IMPORTANT: Used to provide information to perform a procedure more easily.
To Next Page
Loading...
Need help?
General
