Brought to you by PCS Electronics, www.pcs-electronics.com
Appendix B – Setting up remote control via Ethernet
Software installation
Download the latest EthernetVirtualPort.exe from our website. You can find it here:
http://www.pcs-electronics.com/phpBB2/viewtopic.php?t=2268
Once you have the driver run the setup file and install the program on your computer. This process is very straight-forward
and should only take a few minutes. Wait for the installation to complete and then start the program.
Connect the amplifier to your network via Ethernet cable. The Ethernet adapter is setup to accept IP from your router’s
DHCP server. It is possible to setup Ethernet adapter with fixed IP or to login directly to ADSL modem. If you need MAC
address of the Ethernet adapter open the cover of the unit and look at the Ethernet adapter, the MAC address is shown on
the adapter. Now create and configure a connection between the PC and CYBERMAXAMP+ as shown below. Note the IP
will differ, but make sure the port is set to 5005!
Fig. 25: Setting up Ethernet connection for CYBERMAXFM+, screen 1
To Next Page
Loading...