Brought to you by PCS Electronics, www.pcs-electronics.com
Front and back panel layout
Fig. 1: Front panel in 2H model
Reference Function
1 Three push buttons, the UP, DOWN and MENU keys or rotary button.
2 LCD display that lets you control the unit and monitor various parameters. 2x16 or 4x16 type.
3 The green led. Green signals power is ON.
4 Red error led or leds. Turns on while VCO is tuning into selected frequency and in case of SWR, TEMP
or other error. There can be several of these depending on the model.
5 Power switch in the middle of the panel is actually a standby switch. To really fully disconnect the unit
from mains power use the main switch at the back.
6 Monitor output at the front provides a small sample of the transmitter signal, this can be used to attach
frequency counter, modulation index monitor, spectrum analyzer or similar equipment.
7 Some models also have VU meter (4 bars). When used for amplifier only last w bars work (power and
reflected power).
Table 1: Front panel in 2H model
Fig. 2: Back panel for 2H model
To Next Page
Loading...