PCWI Battery Charging Clip with NiMH battery & power adaptors
14
PCWI NiMH Battery + Charger Clip BC-1
The BC-1 charging clip is for use with the PCWI NiMH Battery Pack
and PCWI Charger PA-1015 Only.
Indicator Light Operation.
RED = Charging
GREEN = Charged
Flashing Red Green = Battery Conditioning.
Note: BC-1 and BC-1 V2 operate the same except for BC-1 V2 Flashing
Red Green continuously = No battery connected
When battery is first placed into charging Clip the charge circuit
will check the condition of the battery and the Green Indicator will
illuminate.
If the battery is OK for charging the Indicator Light will change from
Green to Red. It may take 5 to 10 seconds for the battery to be checked.
If the battery is defective or is less than 9 volts the Charge Indicator light
will flash from Red to Green. During this time the charge circuitry will
trickle charge the battery if possible.
The BC-1 Battery Clip will fast charge the battery to 75% of capacity
in approximately 4 hours. The remaining 25% charge will occur in
approximately 20 Hours.
If BC-1 Charge Clip is used with PCWI AC/DC Adapter Model No:-
Select. A Part No:- SA48-1005 the battery will not be fast charged.
To Next Page
Loading...
