Peak 212 - Load Testing; Operation Instructions; Lifting a Vehicle

28
4. Test with load
After finishing the above adjustment, test running the lift with load. Run the lift in
low position for several times first, make sure the lift can rise and lower
synchronously, the Safety Device can lock and release synchronously. And then test
run the lift to the top completely. If there are anything improper, repeat the above
adjustment.
NOTE: It may be vibrated when lifting at start, please lifting it with load for
several times, the air would be bled and the vibration would be
disappeared automatically.
Fig. 42 Hydraulic System
VI. OPERATION INSTRUCTIONS
Please read the safety tips carefully before operating the lift
To lift vehicle
1. Keep clean of site near the lift;
2. Position lift arms to the lowest position;
3. To shortest lift arms;
4. Open lift arms;
5. Position vehicle between columns;
6. Move arms to the vehicle’s lifting point;
Note: The four lift arms must at the same time contact the vehicle’s lifting point
where manufacturers recommended
7. Push button “UP” until the lift pads contact underside of vehicle totally. Recheck to
make sure vehicle is secure;