What to do if Peak 209 lift raises slowly?
If your Peak Lifting System lift is raising slowly, it could be due to several factors. The oil line might be jammed (clean the oil line), the motor might be running on low voltage (check the electrical system), the oil could be mixed with air (fill the tank), the gear pump might be leaking (replace the pump), or you might be experiencing overload lifting (check the load).
What to do if Peak 209 Lifting Systems motor runs but the lift is not raised?
If the motor of your Peak Lifting System runs but the lift does not raise, it could be due to several reasons: the motor might be running in reverse rotation (reverse two power wires), the gear pump might be out of operation (repair or replace it), the release valve could be damaged (repair or replace it), the relief valve or check valve might be damaged (repair or replace them), or the oil level might be low (fill the tank).
Why Peak 209 Lifting Systems lift does not stay up?
If your Peak Lifting System lift does not stay up, it might be because the release valve is out of work (repair or replace it), the relief valve or check valve is leaking (repair or replace them), or the cylinder or fittings are leaking (repair or replace them).
How to troubleshoot Peak 209 lift that can not lower?
If your Peak Lifting System lift cannot lower, it might be due to the following reasons: the safety devices are locking (release the safeties), the release valve is damaged (repair or replace it), the safety cable is broken (replace it), or the oil system is jammed (clean the oil system).
Why Peak 209 Lifting Systems motor does not run?
The motor of your Peak Lifting System might not be running due to several reasons: the button may not work (in this case, replace the button), the wiring connections might be in poor condition (repair all wiring connections), the motor could be burned out (repair or replace the motor), or the AC contactor might be damaged (replace it).
General| Brand | Peak |
|---|---|
| Model | 209 |
| Category | Lifting Systems |
| Language | English |
Details specific features of the Model 209 lift.
Details specific features of the Model 209X lift.
Illustrates arm swing dimensions for Model 209.
Illustrates arm swing dimensions for Model 209X.
Lists all necessary tools for installation.
Requirements for the concrete floor for safe installation.
Details electrical power needs for the lift.
Choosing a suitable installation location.
Using chalk lines to mark the baseplate installation.
Verifying the packaged lift and power unit.
Checking parts for models 209 and 209X from cartons.
Instructions for placing the powerside columns.
Guide for connecting the lift's internal cables.
Instructions for connecting hydraulic oil hoses.
Steps for checking and adjusting column plumbness.
Procedures for drilling and tightening anchor bolts.
Steps for fitting safety mechanisms and cables.
Instructions for attaching protective covers.
Guide to attaching and adjusting the lifting arms.
Process for adjusting the lifting arm locking mechanism.
Connecting PEAK and SPX single phase motors.
Connecting three phase motors.
Detailed illustration of Model 209 parts and assembly.
Detailed illustration of Model 209X parts and assembly.
Exploded view of hydraulic cylinder parts.
Exploded view of power unit parts.
Ensuring synchronized carriage movement.
Adjusting the safety cable for proper function.
Performing a test with a load after adjustments.
Step-by-step guide for lifting vehicles.
Step-by-step guide for lowering vehicles.
Recommended monthly checks and lubrication.
Recommended checks and inspections every six months.
Common problems with the motor and power unit.
Solutions for lifts that do not raise or raise slowly.
Solutions for lifts that cannot be lowered.
Comprehensive parts list for Model 209.
Comprehensive parts list for Model 209X.
Parts list for hydraulic cylinder components.
Parts lists for single and three-phase power units.
To Next Page
