Товариство з обмеженою відповідальністю "АЛДІТОП"
Продажа 050-660-22-31
Сервис 050-415-60-94
O. Install Electrical System
Connect the power source on the data plate of Power Unit.
Note: 1. For the safety of operators, the power wiring must contact the floor well.
2. Pay attention to the direction of rotations when using 380V, three phase
motors.
PEAK single phase motor (See Fig. 35).
1. Connecting the two power supply lines (active wire L and neutral wire N) to
terminals of AC contactor marked L1, L2 respectively.
2. Connecting the two motor wires to terminals of AC contactor marked T1, T2.
3. Connecting A2 to L2 of AC contactor.
4. Terminal 4# of control button is connected with terminals A1of AC contactor;
Terminal 3# of control button is connected with terminals L1of AC contactor.
SPX single phase motor for Model 209/209X (See Fig. 36).
1. Power supply line (active wire L) is connected
with wire of control button.
2. Wire of control button is connected
with wire of motor.
3. Power supply line (neutral wire N) is
connected with wire of motor.
To Next Page
Loading...
