Atlas LCR User Guide April 2012 – Rev 5
Page 13
Self Tests
Many internal functions are tested each time the unit is powered up. If any of
these self tests do not meet tight
performance limits, a message will be
displayed similar to the following:
The unit will then switch off.
It is possible that a temporary condition caused the failure and restarting the
unit may clear the problem. If the fault persists please contact Peak Electronic
Design Ltd or an authorised agent with details of the error message for further
advice.
Please note that some internal tests cannot be performed if a low battery
warning has been displayed. This means that if there is an internal problem, a
low battery condition can prevent the error condition from being displayed. It
is therefore strongly recommended that a low battery is replaced as soon as a
“Low Battery” message is displayed.
Error 02
Error 02Error 02
Error 02
To Next Page
Loading...
