PEAK FCB4N2-Programmable MIDI foot controller
Page 3 of 9
INTRODUCTION
Overview.
The FCB4N2 is a programmable MIDI foot controller that supports all standard MIDI devices. This is an
upgraded version 2.0 that can be programming with MIDI messages and saved to EPROM memory. Up to
128 memory presets can be arranged in 32 banks of 4 presets. You can assign any MIDI Program Change
(PC) and Continuous Controller messages (CC) into each preset (4PC and 8CC messages per preset, all on
different MIDI channels).
The FCB4N2 has up/down bank and 4 patch selection buttons, all with high quality heavy duty foot switches
that you can feel when pressed. The chassis is made of aluminum, folded by a laser cutting process and
finished with a black anodized coating. It is a compact, rugged, simple to use, fully programmable MIDI foot
controller.
Top Panel.
BANK UP/DOWN SWITCH: This is used to increase the bank up or decrease the bank down from the
current state. The current bank starts from bank#1 up to a maximum of
bank#32.
PRESET SWITCH: The FCB4N2 has 4 patches in a bank labeled as P1, P2, P3 and P4. You
also use these switches in programming mode to edit, enter, save or cancel.
BANK/PROGRAM DISPLAY: The seven segment display has 2 digits showing mode when you are
editing/setting a program or displaying the bank number when you are in
operating mode. The MIDI number runs from 0 to 127 which means that
the displayed number will be from 00 to 2.7. If the number is over 99 it
shows the number with a decimal point.
To Next Page
Loading...