PEAK FCB4N2-Programmable MIDI foot controller
Page 8 of 9
5. As shown on the diagram above you can set each parameter for the selected preset step by
step. If you don’t want to transmit some MIDI messages you can set them to
“oF” (meaning
“OFF”) and skip to the next parameter.
6. You can save settings to a preset memory by pressing the
P4 switch. The FCB4N2 will exit
programming mode and will return back to the operation mode.
7. If you don’t want to save any changes please press P3 switch. The FCB4N2 will exit
programming mode without saving any changes and return back to the operation mode.
Note: You can press P1 switch to see the current setting topic/menu.
Factory Restore
You can reset the FCB4N2 to the factory default settings. The data that you saved in the EEPROM memory
will be erased and the unit returned back the factory default settings. You can restore the factory default by
following these steps:
1. Unplug the power from the FCB4N2 unit.
2. Press and hold
P4 switch if you want to start from MIDI PC#0 at first in the Bank1-P1 or press
and hold
P3 switch if you want to start from MIDI PC#1 (ie: POD2.0 needed).
3. Plug the power into the FCB4N2 unit.
4. The
BANK/PROGRAM display will be flashing with a dot, it is processing a restore.
5. Once you see the display is on the unit is processing and you can release the
P4 switch.
6. Wait for a moment until restore process has completed. The FCB4N2 will be initialized with the
factory default settings.
MIDI Implementation
MIDI Channel: Default: 1
(Transmitted) Changed: 1 - 16
Program Change#: 0 – 127 can be setting up to 4 program change messages
transmitted per preset. (With different MIDI channels)
Controller#: 0 – 127 can be setting up to 8 controllers with transmitted per
preset. (With a CC MIDI channel)
Control Change Value: 0 – 127 setting value in each controller.
: tr momentary for toggle the control change value by
value 0-63 = OFF (momentary off value = 0)
value 64-127 = ON (momentary on value = 127)
The FCB4N2 can be transmitting MIDI messages with 4PC and 8CC per preset. The programming mode can
be setting follow by the default setting below:
PC1 MIDI Channel#: CH#1 – CH#16
(selectable but default is CH#1)
PC1 Program Change#: PC#0 – PC#127
(selectable but default is PC#0)
PC2 MIDI Channel#: CH#1 – CH#16
(selectable but default is OFF)
PC2 Program Change#: PC#0 – PC#127
(selectable but default is PC#0)
PC3 MIDI Channel#: CH#1 – CH#16
(selectable but default is OFF)
PC3 Program Change#: PC#0 – PC#127
(selectable but default is PC#0)
To Next Page
Loading...