EasyManua.ls Logo

Peavey Classic 50 212

Peavey Classic 50 212
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
www.peavey.com
Classic
®
50 212/410
GUITAR AMPLIFIER
Operating
Manual
Question and Answer IconNeed help?

Do you have a question about the Peavey Classic 50 212 and is the answer not in the manual?

Peavey Classic 50 212 Specifications

General IconGeneral
TypeTube Amplifier
Power Output50 Watts
Speaker Configuration2 x 12"
Preamp Tubes3 x 12AX7
Power Tubes4 x EL84
Effects LoopYes
ReverbYes
Channels2
FootswitchYes
Tubes3 x 12AX7 (preamp), 4 x EL84 (power amp)
Dimensions292 mm (D)
ControlsPre Gain, Normal Volume (Clean Channel), Master Volume (Lead Channel), Bass, Middle, Treble, Reverb, Presence, Channel Select Switch, Standby Switch, Power Switch
Weight60 lbs (27.2 kg)

Summary

Front Panel Controls

Power Switch

Switch to the "ON" position to turn on the apparatus.

Standby Switch

Allows the amplifier to be placed in standby or active mode.

Channel Select Switch

Allows selection of the Lead or Normal channels.

Pilot Light LED

Illuminates when AC power is being supplied to the amplifier.

Presence Control

Boosts extreme high frequencies by up to 6 dB.

Master Volume Control

Controls the overall volume level of the system.

Tone Controls (EQ)

Passive tone controls for bass, middle, and treble frequencies.

Reverb Control

Provides an echo effect; can be controlled by remote footswitch.

Additional Front Panel Features

Post Gain Control

Controls the overall volume level of the Lead channel.

Pre Gain Control

Controls the input volume level of the Lead channel.

Normal Gain Control

Controls the volume level of the Normal channel.

Bright Input

Input for enhanced high frequency response.

Normal Input

Input for instrument-level signals.

Rear Panel Connections

Fuse Holder

Protects the apparatus from overcurrent; replacement requires same type and value.

Ground Switch

Three-position switch to minimize audible hum and noise.

Speaker Outputs

Connect external speakers for 16 or 8 ohm loads.

Remote Switch Jack

Connects an optional footswitch for channel select and reverb.

Effects Loop

Includes Effects Send and Effects Return for external processing.

Product Specifications

Power Amplifier Section

Details on tubes, rated power, and frequency response.

Preamp Section

Specifications for preamp tubes, input levels, and equalization.

Effects SendReturn

Technical details for signal routing to/from external effects.

External Footswitch Function

Describes footswitch operations for channel selection and reverb.

Limited Warranty Information

Warranty Coverage Details

Specifies what the warranty covers and does not cover.

Warranty Duration

Outlines the warranty periods for different product categories.

Obtaining Warranty Service

Instructions on how to get the product repaired under warranty.

Limitations and Exclusions

Details implied warranties, liability limits, and damage exclusions.

Related product manuals