Loudspeaker System Specifications
3
Input for two of the three input channels is via a combo female XLR and 1/4” TRS
phone jack with balanced input to the preamp/EQ electronics, and a level control.
For these two channels, a switch is provided to change between line level gain
and mic level gain. A third channel is for a Bluetooth® source, or alternatively a
1/8" AUX input jack. Each channel has an adjustable Level control knob, and
also a three-band EQ section that is accessible via the DSP menu Push knob.
There is a balanced output, a Male XLR, that can feed the mixed signals from the
three channels out to another component. This output allows linking of additional
speaker systems, or feed of the signal to a powered subwoofer, etc.
The cabinet of the PVX™p 10 Bluetooth® speaker system has multiple mounting
fly points, providing outstanding versatility in permanent install use. A pair of
widely spaced M8 inserts is molded-in on the top, and a pair on the bottom, and
a set of four M8 inserts is available on the top, on the bottom for use with the
Versamount™ 70, and one M8 on the rear near the bottom. This is a total of 13
mounting inserts in all. All of these inserts have retaining hardware on the inside
of the plastic cabinet, providing a more reliable and safe mode of mounting the
cabinet.
Applications
The Peavey PVX™p 10 Bluetooth® has a variety of applications such as sound
reinforcement, public address, side fill system, karaoke or musical playback.
The multiple fly points make use as a permanent install system very convenient
with lots of installation flexibility.
A typical signal source for the line-level inputs of the Peavey PVX™p 10
Bluetooth® would be a sound reinforcement mixing console (mixer) or the output
from a CD player, MP3 player or tape deck. The Bluetooth® link provides for
many modern devices to link to the system, such as smart phones, digital mixers,
etc. A typical dynamic microphone can be connected directly via the XLR input
and used as well.
To Next Page
Loading...
Need help?
General
