Peavey Special 212 - Specifications; Rated Power and Impedance; Preamp Section Specifications

SPECIFICATIONS
Rated Power & Load:
Power specs measured with
T. Dynamics @ 100%
130 W RMS into 8 ohms
220 W RMS into 4 ohms
Power @ Clipping: (typically)
(5% THD, 1 kHz, 120 V AC line)
130 W RMS into 8 ohms
220 W RMS into 4 ohms
Frequency Response:
+O, 3 dB, 60 Hz to 20 kHz,
@ 100 W RMS into 8 ohms
Hum 81 Noise:
Greater than 86 dB below
rated power
Power Consumption:
Domestic: 600 W @ 60 Hz,
120 VAC
Export: 600 W @ 50/60 Hz,
220-2301240 V AC
PREAMP SECTION
The following specs are measured @
2 kHz with the controls preset as follows:
Push Bright, Off (out)
Channel Select Normal (out)
Low& High @ IO
Mid @ 0
Resonance & Presence @ 0 dB
Pre & Post Gain @ IO
Gain 6: Thrash, Off (out)
Normal Levels are with normal
volume @ 5
Minimum Levels are with normal
volume @ IO
Shift, Off (out)
Bottom, Body, & Edge @ 0
T-Dynamics @ 100%
Preamp High Gain Input:
Impedance: High-Z, 1 M ohm
Nominal Input Level: -24 dBV,
60 mV RMS
Minimum Input Level: -34 dBV,
20 mV RMS
Maximum Input Level: 0 dBV,
1 VRMS
Preamp Low Gain Input:
Impedance: High-Z, 44 k ohms
Nominal Input Level: -18 dBV,
120 mV RMS
Minimum Input Level: -28 dBV,
40 mV RMS
Maximum Input Level: 6 dBV,
2VRMS
Effects Send:
Load Impedance: 1 K ohm
or greater
Nominal Output Level: -10 dBV,
0.3 V RMS or 0 dBV, 1 V RMS
if Effects Level is in
Effects Return:
Impedance: High-Z, 18 K ohms
Designed Input Level: -10 dBV,
0.3 V RMS or 0 dBV, 1 V RMS
if Effects Level is in
(Switching jack provides Effects Send to
Effects Return connection when not used)
Preamp Output:
Load Impedance: 1 K ohm
or greater
Nominal Output Level: 0 dBV,
1 VRMS
R.O.C. Invention Patent No. 072727
Power Amp Input:
Impedance: High-Z, 50 K ohms
Designed Input Level: 0 dBV,
1 VRMS
(Switching jack provides preamp output to
power amp input connection when not
used)
System Hum & Noise @
Nominal Input Level:
(20 Hz to 20 kHz un weigh ted)
72 dB below rated power
Equalization:
Special Low, Mid, & High
passive type EQ
Special Bottom, Body, &
Edge EQ
Push Bright: +6 dB @ 2 kHz
Push Shift: Shifts Ultra Channel
Body Frequency
Push Thrash: -20 dB notch @
1 kHz in Lead channel
Push Gain: Increases Lead or
Ultra gain
Resonance: +6 dB @ cabinet
resonance
Presence: +6 dB @ 5 kHz
External Footswitch Functions:
Lead/Ultra Select (when
Channel Select button is in)
Clean Bypass
Effects Loop Bypass
Dimensions 81 Weight:
20.75” H x 26.625” W x 11.75” D
64.8 Ibs.
Due to our efSorts,for constant improvements,
,feutures and specifications LiJ ted herein are subject to charge without notice.
6