Peavey VYPYR PRO - Creating and Editing Amplifier Presets; Model and Parameter Editing Process; Delay and Reverb Configuration Guide

•e dierent types of models are color coded. Amps are red, Instruments (M1 slot only) are yellow, stomp
boxes are orange and eects are blue.
•If there is already a model present, you can change either the type of currently chosen model or you can
change the overall type of model. For instance, if there is already an amp present, to change the type of amp
model, simply turn the dial to select a dierent amp and press the model encoder. To change the type of model,
push and release the MODEL SELECT button, which changes the 4 model screens to MODEL TYPE SELECT
MODE.
•If there isn’t a model type present, there is no need to press the MODEL SELECT button. Simply turning the
model encoder will automatically change the model screens to MODEL TYPE SELECT MODE.
•If a change in order of models is desired, press and hold the MODEL SELECT button. e master LCD screen
will read “MODEL 1-4 SWAP MODEL POSISTIONS”. In this mode, turning any of the 4 model encoders will
move that model back and forth within the preset order. For example, if there are 3 models chosen and the M4
position is empty and you wish to add a new eect at the beginning of the signal chain, such as a compressor,
you would press and hold the MODEL SELECT button and move all 3 of the models to the right 1 position. is
will leave the M1 slot open and you can then select a new model for that position.
•To edit each model’s parameters, including amp models, press and release the cooresponding model’s encoder
(NOTE: pressing and holding the model encoders will bypass that model. is is shown on the model screen as
lower case letters). When the model is chosen, the corresponding screen is brighter, and the parameter encoders
can be turned to change the desired parameters. Anytime a parameter is tweaked, the master LCD screen will
show the name of the parameter as well as the value.
•VERY IMPORTANT. With the Vypyr, delay and reverb are always available, they do not need to be chosen as
a stomp or eect model as is the case with other modeling amps. To change the settings to the delay and reverb,
including turning them o, press and release the DEL/REV EDIT button which is righ next to the TAP TEMPO
button. is will change the mode of the amp to QUICK EDIT DELAY/REVERB mode. In this mode, the 5
parameter encoder’s functions change from the top line of text to the bottom line of text. Turning the param-
eter encoders will change the Delay Level, Time Shi (delay times are set using the tap tempo button), Delay
Feedback, Reverb Room Size and Reverb Level. To turn o the delay or reverb, simply adjust the Delay Level or
Reverb Level down to 0.
Creating and Editing Presets