Pg. 14 Pg. 15
Meter Programming & Use
The LCD meter on your Pedego can be programmed to change various functions.
Hold “SET” for 2 seconds to enter the setup interface.
“SET 1” - Press [-] and the Trip will reset to 0.
“SET 2” - Set the max speed.
“SET 3” - Set the wheel size.
“SET 4” - Set the bike in either MPH or KPH
Hold “SET” for 2 seconds to exit the setup interface.
Press the set button (second button) to switch the display information. The
order is: Trip Distance (TRIP), Riding Time (TIME), and Odometer (ODO).
Press the power button (top button) once while the meter is on to turn on the
backlight, as well as the integrated front and rear lights on the Pedego. Press it once
more to turn the lights and backlight off.
For Boomerang Plus, City Commuter, Interceptor, & Trail Tracker
Each LCD Meter comes with a USB
port attached to the bottom of the meter to
charge your mobile devices. Hold down the
[+] and set buttons for 2 seconds to turn on
the USB charging. Hold the same buttons
again for 2 seconds to turn this feature off.
The bars are an indicator that displays the amount of power that is being
drawn from the battery. The more bars that are displayed, the more battery
power is being used to power the Pedego.
After 5 minutes of inactivity, the LCD Meter will automatically turn off to conserve
power.
To Next Page
Loading...
Need help?
General
