What to check if my PEERLESS PureFire PF-200 Boiler shows a low water error?
Check the boiler water level, low water cut-off, and harness. If a LWCO is not used, a jumper should be placed between terminals #9 and #10, LWCO Contact.
How do I fix a blocked condensate drain on my PEERLESS PureFire PF-200?
If your PEERLESS Boiler shows a 'BLOCKED CONDENSATE DRAIN' error, check the condensate tanks, hoses, condensate switch, and harness.
General| AFUE | 95% |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Boiler Type | Condensing |
| Ignition Type | Direct Spark Ignition |
| Heat Exchanger Material | Stainless Steel |
| Input BTU/h | 200, 000 |
| Output BTU/h | 190, 000 |
| Efficiency | 95% |
| Water Connections | 1 1/4" NPT |
| Firing Rate (Input) | 200, 000 BTU/hr |
| Vent Size | 3" |
To Next Page