7 of 16
ISSUED: 02-05-09 SHEET #: 202-9331-1
Refer to Screen Compatibility Chart to determine the proper fastener to use. Visit www.peerlessmounts.com/6
for a full screen compatibility chart for this mount.
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket (BB or CC) into
screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place.
Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the
baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
Refer to Screen Compatibility Chart to determine the proper fastener to use. Visit www.peerlessmounts.com/6
for a full screen compatibility chart for this mount.
Begin with longer length screw, hand thread through multi-washer, adapter bracket (BB or CC) and spacer in that
order into screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug
into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw
from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
For Flat Back Screen
For Bump-out or Recessed Back Screen
2-2
2-1
If you have any questions, please call Peerless customer care at 1-800-865-2112.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
fig 2.2
SCREW
MULTI-WASHER
SCREEN
SPACER
fig 2.1
SCREW
MULTI-WASHER
ADAPTER BRACKET (BB or CC)
SCREEN
ADAPTER BRACKET (BB or CC)
To Next Page
Loading...
