23
Owner’s manual
EN
1. Dashboard
2. Nut (5mm)
3. Spring Washer
4. Screw (5 x 25mm)
5. Screw
6. Strap
Be sure to use the strap to secure the back
of the unit in place. The strap can be bent
by hand to the desired angle.
7. Plain Washer
1. Frame
2. Insert ngers into the groove in the
front of frame and pul l out to remove
the frame. (When reatt achi ng the
frame, point the side with a groove
dow nwards and attach it. )
3. Lever
Insert the levers supp lied with the uni t into
the grooves at both sides of the uni t ad show
n in gure unti l they click. Pulling the levers
makes possible to remove the unit fro m the
dashboard.
DIN REAR-MOUNT (Method B)
1. Select a position where the screw
holes of the bracket and the screw holes of the
main unit become aligned (are tted), and tighten
the screws at 2 places on each side. Use either
truss screws (5 x 5mm) or ush surface screws
(4 x 5mm)
2. Screw
3. Dashboard or Console
INPUT THE SD CARD
The SD oblique angle keeps
upward exposure, put into
the SD slot and press it again
to eject.
Rys.2
Rys.3
DIN FRONT-MOUNT (Method A)
1. Dashboard
2. Holder
After inserting the holder into the
dashboard, select the appropriate
tab according to the thickness of the
dashboard material and bend them
inwards to secure the holder in place
3. Screw
To Next Page
Loading...
Need help?
General
