EN 8
Igniting and adjusting
A symbol above the control knob indicates which burner is being
oparated.
Spark ignition
• Press the control knob in and turn it anti-clockwise.
• The burner ignites. In the case of appliances with flame failure
device you must hold the control knob pressed in for approximately
5 seconds to switch the flame failure device on.
If the burner does not ignite, check wether:
- the burner head is correctly installed;
- the buner parts are clean and dry.
Each burner can be adjusted continuously between the high and low
positions.
Caution: glass lid may shatter when heated. Turn off all burners before
shutting the lid.
OPERATING
1. Burner indication
2. 0-setting
3. High setting
4. Low setting
To Next Page
Loading...
