SETTING UP THE TREAD CONTINUED
12
LEVELING
If the Tread rocks or wobbles, stabilize it by adjusting
the back feet.
•
Use a 27mm wrench or an adjustable wrench to
loosen the nut at the top of each back leg.
•
Turn one or both feet clockwise until all feet rest
rmly on the ground.
•
Tighten the locking nuts.
NOTE: The front feet of the Tread are not adjustable.
Attempting to adjust the front feet could damage the
Tread and compromise incline accuracy.
LOCATION REQUIREMENTS
CONTINUED
•
Make sure the Tread is situated within reach of an
outlet. The provided power cord must be able to reach
the outlet at minimum and maximum incline, with
some slack. The power cord must never pass under
the Tread.
•
Bootcamp and Floor classes take place off or partially
off the Tread. Make sure that you have adequate space
to work out behind or alongside the Tread.
To Next Page
Loading...
