PressureMAT User Guide
Revision 8
Page 29/48
Time Alarm- This value is set to a default of 0000 hours. This can be set to trigger an alarm
in a set period of time and most likely will remain at 0000 hours which indicates it is not
active. Press the SELECT/PROG with Alarm Valid selected.
Use the RIGHT ARROW button on the keypad until you get to the digit that you want to
change. Use the DOWN ARROW/UP ARROW buttons on the keypad to change the values.
To change a digit from a numerical value to zero, change the value to a zero. When the correct
value has been selected, press the SELECT/PROG button and the value will be confirmed. To
escape from this menu without changing the value, press the BACK button and the main
channel menu will appear.
To Next Page
Loading...
