Even though we know that you are eager to get going, we urge you to take a few minutes to read through this part of the
introductory chapter carefully before plugging the line connector into the wall outlet.
This instrument has been designed and tested for Measurement Category I, Pollution Degree 2, in accordance with
EN/IEC 61010-1:2001 and CAN/CSA-C22.2 No. 61010-1-04 (including approval). It has been supplied in a safe
condition. Study this manual thoroughly to acquire adequate knowledge of the instrument, especially the section on
Safety Precautions hereafter and the section on Installation on page 1-7.
2.2.2. Safety Precautions
All equipment that can be connected to line power is a potential danger to life. Handling restrictions imposed on such
equipment should be observed.
To ensure the correct and safe operation of the instrument, it is essential that you follow generally accepted safety
procedures in addition to the safety precautions specified in this manual.
These units are designed for indoor use only.
The instrument is designed to be used by trained personnel only. Removing the cover for repair, maintenance, and
adjustment of the instrument must be done by qualified personnel who are aware of the hazards involved.
The warranty commitments are rendered void if unauthorized access to the
interior of the instrument has taken place during the given warranty period.
2.2.2.1. Caution and Warning Statements
CAUTION: Shows where incorrect procedures can cause damage to, or
destruction of equipment or other property.
WARNING: Shows a potential danger that requires correct procedures or
practices to prevent personal injury.
2.2.2.2. Symbols
Shows where the protective ground terminal is connected inside the instrument. Never remove or loosen this
screw
This symbol is used for identifying the functional ground of an I/O signal. It is always connected to the
instrument chassis.
Indicates that the operator should consult the manual.
One such symbol is printed on the instrument, below the A and B inputs. It points out that the damage level for the input
5 / 50
To Next Page
Loading...
Need help?
General
