Arctica 4806xp switch Installation Guide Chapter 2 Installation Notice
4
with the electronic equipment or lightning protection devices;
■ Keep away from high power radio transmitters, radar transmitters, and high frequen-
cy strong circuit devices;
■ Provide electromagnetic shielding if necessary.
2.1.6.Rack Configuration
The dimensions of the Arctica 4806xp is designed to be mounted on a standard 19’’
rack, please ensure good ventilation for the rack.
■ Every device in the rack will generate heat during operation, therefore vent and fans
must be provided for an enclosed rack, and devices should not be stacked closely.
■ When mounting devices in an open rack, care should be taken to prevent the rack
frame from obstructing the switch ventilation openings. Be sure to check the posi-
tioning of the switch after installation to avoid the aforementioned.
Caution！
If a standard 19’’ rack is not available, the Arctica 4806xp can be placed on a clean
level desktop, leave a clearance of 100mm around the switch for ventilation, and do not
place anything on top of the switch.
2.2.Installation Notice
■ Read through the installation instruction carefully before operating on the system.
Make sure the installation materials and tools are prepared. And make sure the in-
stallation site is well prepared.
■ During the installation, users must use the brackets and screws provided in the ac-
cessory kit. Users should use the proper tools to perform the installation. Users
should always wear antistatic uniform and ESD wrist straps. Users should use
standard cables and connecters.
■ After the installation, users should clean the site. Before powering on the switch, us-
ers should ensure the switch is well grounded. Users should maintain the switch
regularly to extend the lifespan of the switch.
■ Statement indicating that a readily accessible disconnect device shall be incorpo-
rated in the building installation wiring.
2.3.Security Warnings
■ When using SFP/SFP+/QSFP+ transceiver, do not stare directly at the fiber bore
when the switch is in operation. Otherwise the laser may hurt your eyes.
■ Do not attempt to conduct the operations which can damage the switch or which can
cause physical injury.
■ Do not install, move or disclose the switch and its modules when the switch is in op-
eration.
■ Do not open the switch shell.
To Next Page
Loading...