Need help?Do you have a question about the PENKO 1020 Series and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Power Supply | 115/230 VAC or 24 VDC |
| Operating Temperature | -10°C to +40°C (14°F to 104°F) |
| Communication | Serial: RS232/RS485 |
| Input Voltage | 115/230 VAC or 24 VDC |
| Output Current | Not specified in provided documents |
| Dimensions | 192 x 96 x 145 mm (7.56 x 3.78 x 5.71 inch) |
Explains how to switch between the two main display screens using the left or right key.
Details on downloading and using PENKO Pi Mach II and PDI Client software for device configuration.
Guides users through the device's menu structure and system setup for configuration.
Overview of supported industrial protocols like Modbus, Profibus, EtherNet/IP, and ASCII for device configuration.
Detailed explanation of configuration parameters like Dosing, Weighing, Stability, H-Time, and K.E.B. time.
Defines parameters related to recipes, including Setpoint, Turnover, Inflight, and tolerances.
Describes parameters that can be read live using industrial protocol register functions.
Details the function and markers for Start/Stop, Accept tolerance, and Start dosing/release inputs.
Describes the function of Coarse, Fine, Ready, Release/Alarm, and Dosing speed outputs.
Step-by-step explanation of the out-dosing process, including start, coarse/fine dosing, and tolerance checks.
Details the procedure for in-dosing when a release valve is used, noting Weighing parameter settings.
Describes the in-dosing process without a release valve, including Weighing parameter notes.
Configuration of DAC settings, including indicator, min/max values, and mode.
Setup for weigher parameters such as unit label, step, decimal point, operation mode, and max load.
Configuration of stable condition parameters, including range and time settings.
Setup for digital filter settings, including cutoff frequency and frequency.
To Next Page
