4 / 82
EN- Raychem920series-IM-H5687405/15
INDUSTRIAL HEAT TRACING SOLUTIONS
INTRODUCTION
Installation and Maintenance Instructions for Firmware Versions up to and Including V3.2X
This manual provides information pertaining to the installation, operation, testing, adjustment,
and maintenance of the Raychem Model 920 Series Heat Trace Control and Monitoring products.
Additional copies of the operating manual may be ordered separately through your Pentair
Thermal Managament representative or online at www.thermal.pentair.com using the document
number H56874.
Notice: The information contained in this document is subject to change without notice.
CERTIFICATION
Pentair Thermal Managament certifies that this product met its published specifications at the
time of shipment from the Factory.
LIMITED WARRANTY
This Pentair Thermal Managament product is warranted against defects in material and
workmanship for a period of 18 months from the date of installation or 24 months from the date of
purchase, whichever occurs first. During the warranty period, Pentair Thermal Managament will,
at its option, either repair or replace products that prove to be defective.
For warranty service or repair, this product must be returned to a service facility designated by
Pentair Thermal Managament. The Buyer shall prepay shipping charges to Pentair Thermal
Managament and Pentair Thermal Managament shall pay shipping charges to return the product
to the Buyer. However, the Buyer shall pay all shipping charges, duties, and taxes for products
returned to Pentair Thermal Managament from another country.
Pentair Thermal Managament warrants that the software and firmware designated by Pentair
Thermal Managament for use with the Raychem 920 Controller will execute its programming
instructions properly. Pentair Thermal Managament does not warrant that the operation of the
hardware, or software, or firmware will be uninterrupted or error-free
WARRANTY EXCLUSION/DISCLAIMER
The foregoing warranty shall not apply to defects resulting from improper or inadequate
maintenance by the Buyer, Buyer-supplied software or interfacing, unauthorized modification or
misuse, operation outside of the specifications for the product, or improper installation.
No other warranty is expressed or implied. Pentair Thermal Managament disclaims the implied
warranties of merchantability and fitness for a particular purpose.
EXCLUSIVE REMEDIES
The remedies provided herein are the buyer’s sole and exclusive remedies. Pentair Industrial Heat
Tracing Solutions shall not be liable for any direct, indirect, special, incidental, or consequential
damages, whether based on contract, tort, or any other legal theory.
CONDUCTED AND RADIATED EMISSIONSFCC/DOC STATEMENT OF COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial envi-ronment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own
expense.
This equipment does not exceed Class A limits for radio emissions as set out in Schedule V to VIII
of the Radio Interference Regulations of Communication Canada.
Cet apparel respecte les limites de bruits radioelectriques applicables aux appareils numeriques
de Classe A prescrites dans la norme sur le materiel brouilleur: “Appareils Numeriques,” NMB-
003 edictee par le Ministre des Communications.
To Next Page
Loading...