56 6EM Thru 18GM - 1100 Vertical Turbine Pumps
SECTION 6 REPAIR PARTS
Ordering Parts
When ordering parts, give pump serial
number, size, model number, a complete
description, and item number of each part.
Refer to the drawings and parts list in the
drawing section of this manual. You may
order parts from your local Layne/Verti-Line
distributor. Consult you local telephone
yellow pages under “Pumps” for the office
nearest you.
You may also contact Layne/Verti-Line
directly as follows:
Layne/Verti-Line
3601 Fairbanks Avenue
Kansas City, KS 66106
Phone (913) 371-5000
Fax (913) 748-4030
Recommended Spare Parts
Refer to Table 1 for a list of recommended
spare parts. This list is for normal duty.
Where severe conditions exist or minimum
down time is critical additional quantities and
those items indicated should be considered.
Table 1 Recommended Spare Parts
Item Description Quantity
13 Sleeve, Top Drive Shaft 1
15 Packing, Set 1
17A Bushing, Packing Box 1
26 Bearings, Line shaft, set 1
29 Sleeve, Line shaft, set 1
31 Couplings, Set 1
34 Bearing, Top Bowl 1
35 Bearing, Inter Bowl, set 1
41 Bearing, Suction 1
50 Bearing Connector, set 1
Gasket, Set 1
Returning Parts
All materials or parts returned to the factory
must have prior approval and a “Returned
Goods Tag”, listing the material to be
returned and the reasons for the return. All
material to be returned should be carefully
packaged to avoid damage in route from
rough handling or exposure to weather.
Contact the factory for shipping instructions.
All material is to be returned freight prepaid.
Layne/Verti-Line makes improvements on its
products from time to time and reserves the
right to furnish improved parts for repairs. A
part that is received and is not identical in
appearance, or has a different symbol from
the original part may be interchangeable.
Examine the part carefully before contacting
your Layne/Verti-Line representative. The
parts should never be returned to the factory
without first obtaining proper authorization
from your Layne/Verti-Line representative.
Predicted Life
The predicted life of parts subject to wear,
shown in Table 2, is based on pumping
liquid without abrasives, the pump operating
at sold conditions and that proper
maintenance is performed.
The actual life encountered for the specific
parts may vary significantly as a result of the
content of liquid pumped, maintenance
performed, actual operating conditions and
other factors.
To Next Page
Loading...
