Why does the Pentair AUTOTROL 460i Control Systems time display keep advancing?
If the time display on your Pentair Control Systems continues to advance, the cause may be a defective time set switch. Replacing the timer should resolve this issue.
General| Model | AUTOTROL 460i |
|---|---|
| Category | Control Systems |
| Control Type | Microprocessor |
| Operating Pressure | 20 - 125 psi (1.4 - 8.6 bar) |
| Operating Temperature | 34° - 120° F (1° - 49° C) |
| Metered or Timed | Metered or Timed |
| Programming | User-Programmable |
| Display | LCD |
Stores data during power outages using NOVRAM, resuming operation seamlessly.
Calculates and adjusts reserve capacity for optimal economy and regeneration.
Reacts to sudden high usage by anticipating a second day of high demand.
Recognizes and ignores days of very low usage for accurate average calculation.
Features solid-state electronics and a simple metering system for long, trouble-free performance.
Set the current time to the closest hour using the TIME SET button.
Set the water hardness from 1 to 99 GPG using the TIME SET button.
Set the capacity from 1 to 99 kilograins using the TIME SET button.
Displays the current time of day; PM light indicates PM hours.
Flashes when service water flows, indicating proper meter operation.
Initiates an extra regeneration cycle by pressing the pointer knob.
Details the manual regeneration steps: Backwash, Brine/Slow Rinse, Brine Refill, Fast Rinse/Refill.
Set the current time to the closest hour using the TIME SET button.
Set the number of days between regenerations, from 1 to 30.
Select between standard AM/PM or 24-hour clock format.
Adjust the pointer knob to set the amount of brine used per regeneration cycle.
Addresses problems like no time display, incorrect time, or time advancing incorrectly.
Covers no water flow display when water is actually flowing.
Solves issues where control regenerates at the wrong time of day.
Addresses timer stalling or continuous regeneration cycles.
Troubleshoots controls that won't regenerate automatically or when the button is pressed.
Diagnoses and resolves issues related to running out of soft water between regenerations.
To Next Page