To Next PageTo Next Page
Need help?Do you have a question about the Pentair SPACOMMAND CP3800 Series and is the answer not in the manual?
General| Brand | Pentair |
|---|---|
| Model | SPACOMMAND CP3800 Series |
| Category | Control Systems |
| Language | English |
Covers installer, pool operator, and owner responsibilities and compliance with codes.
Details support for EasyTouch, IntelliTouch, and Compool systems.
Explains how to upgrade an existing iS10 spa-side remote.
Describes the function of circuit, adjustment, and mode buttons on the remote.
Explains the function of the Water Temperature (WTR TEMP) LED.
Details LEDs for time, pump speed, flow rate, backlight, air temp, and heat.
Explains how to adjust the spa temperature using the remote.
Details controlling IntelliFlo pump speed (RPM) and flow rate (GPM).
Explains how to adjust backlight brightness and view ambient air temperature.
Shows default button assignments for EasyTouch and IntelliTouch systems.
Shows default button assignments for Compool CP3xxx systems.
Lists the items included in the kit and available accessories.
Details required mounting space and water clearance for installation.
Covers conduit preparation and mud-box mounting for recess installation.
Covers conduit preparation for surface mount installation.
Provides a step-by-step guide to remove and replace an existing SpaCommand remote.
Details how to remove the old iS10 remote from surface or recess mounts.
Highlights safety precautions and the overall wiring connection process.
Explains IntelliTouch support for multiple remotes and initial assignment.
Details the process for assigning numbers 2, 3, or 4 to additional remotes.
Guides on configuring button functions via the indoor control panel.
Explains how to set pump speed and flow rate increments for IntelliFlo.
Guides on assigning functions to remote buttons via the EasyTouch control panel.
Guides on setting pump speed and flow increments for IntelliFlo.
Details connecting the remote to a CP3xxx load center using an adapter.
Provides an overview of replacing an SS8 remote with a SpaCommand remote.
Outlines the steps for removing the SS8 remote and installing the SpaCommand remote.
Highlights critical safety warnings and instructions for the kit.
Provides a brief overview of the main installation steps.
Details how to mount the outdoor transceiver module near the load center.
Guides connecting the transceiver cable to the load center circuit board.
Details the wiring configuration for the indoor wireless transceiver.
