SCREENLOGIC
®
INTERFACE Wireless Connection Kit Installation Guide
WARNING Switch OFF the main system power to the Load Center
before making any connections.
1. Unlatch the enclosure door spring latche(s), and open the door.
2. Remove the two retaining screws securing the high voltage cover-
panel, and remove it from the enclosure.
3. Loosen the two access screws securing the control panel.
5
Panel retaining
screw
(Cover-panel
not shown)
Access
screw
Retaining
screw
Access
screw
Control panel
Connect the Transceiver connection cable to the COM Port on Control
System Circuit Board
IntelliTouch
®
or EasyTouch
®
Load Center
4. Lower down the hinged control panel to access the circuit board.
To Next Page
Loading...
