SCREENLOGIC
®
INTERFACE Wireless Connection Kit Installation Guide
Waterfall 2
Water
all 2
1
234
WAN
RJ11
RJ45
INTERNET
1
23 4
WAN
- LAN -
Existing wired or
wireless router
(mandatory)
RJ11 for DSL
Coax for Cable
In-wall Touch
Screen
Wireless transceiver
connected to
Personality board
(COM port)
via 10’ cable
Protocol
Adapter
ScreenLogic
®
Interface
Wireless router
IntelliTouch
®
or
EasyTouch
®
Indoor Control
Panel (*)
Existing PC
Ethernet cable (RJ45 - CAT 5)
Ethernet cable
(RJ45 - CAT 5)
DSL or
Cable Modem
(RJ45)
Cable distance limits:
- Ethernet cable distance limit = 300 feet
- Four-wire cable distance limit = 1500 feet
Note: (*) Optional wiring for existing Indoor
Control Panel. Tap into the Indoor Control
Panel connector or pig tail off the four-wire
cable connected to the Personality board.
Transceiver
connected to
ScreenLogic
Interface
Protocol adapter
Load Center
(Located outside at
equipment pad)
2
4-wire
one foot
cable
AC power
adapter
ScreenLogic
®
Interface Connection Diagram
To Next Page
Loading...
