Pentair SPACOMMAND CP3800 Series - Installation Summary and Diagram Reference; Summary Installation Steps

SCREENLOGIC
®
INTERFACE Wireless Connection Kit Installation Guide
1
Antenna
location
RX: This LED is
on when a signal
is being received
from the wireless
transceiver in the
outdoor clam
shell.
TX: This LED is
on when a signal
is being
transmitted to the
wireless
transceiver in the
outdoor clam
shell.
RS-485 Connector
(to Protocol Adapter)
Power LED
ScreenLogic Interface
(Indoor Wireless Transceiver)
Summary installation steps
The ScreenLogic
®
Interface connection diagram on page 2 shows the
transceiver locations and connections. To install the ScreenLogic Interface
Wireless Connection kit:
• Mount the outdoor transceiver antenna near the IntelliTouch
®
or
EasyTouch
®
Control System Load Center and connect the
transceiver to the COM port connector located in the IntelliTouch
®
or EasyTouch
®
Control System Load Center.
• Use the supplied 12 inch cable to connect the ScreenLogic
Interface indoor wireless transceiver to the ScreenLogic Interface
Protocol adapter. Plug the transceiver AC power adapter into an
AC wall-outlet and into the transceiver unit to power up the unit.
IMPORTANT NOTICE: Be sure
the yellow ID label (9-digit ID
number XXXXXXXXX) located
to the right of the RS-484
connector on front side of
indoor transceiver enclosure
and the ID number on the
ScreenLogic Interface outdoor
wireless transceiver are the
same. See page 1 for label
location.
ID number (Outdoor
transceiver)